indentations

英 [ˌɪndɛnˈteɪʃənz]

美 [ɪnˌdɛnˈteɪʃənz]

n.  缺口; 凹陷; 凹痕; 行首缩进; 行首空格; 造成凹陷(或缺口); 将行首缩进
indentation的复数

柯林斯词典

• 行首缩格,行首留空格
  Anindentationis the space at the beginning of a line of writing when it starts further away from the edge of the paper than all the other lines.
• N-COUNT 凹口;缺口
  Anindentationis a shallow hole or cut in the surface or edge of something.
  1. Using a knife, make slight indentations around the edges of the pastry.
     用刀子绕馅饼边沿刻小锯齿。

双语例句

• A new experimental measurement of residual stresses around Vickers ′ indentations on the surface of the SiC/ Al 2O 3 nanocomposites is proposed with the aid of a Raman microprobe.
  提出了用拉曼显微镜测试SiC/Al2O3纳米复合材料表层V氏压痕周围残余应力的新方法。
• Invisible ink, pinpricks and indentations on letters were all used to convey details of troop movements, bombing raids and ship-building.
  信中的隐性墨水、针眼和印凹痕都透露着部队动向、炸弹突袭和军舰装备等信息。
• PITTED: Small indentations appearing as black dots on finished surfaces of any piece of product; undesirable surface defects.
  麻面：在任何成品零件的表面上出现的小的黑色的麻点，这是不希望的缺陷。
• The varying distance between the microhardness indentations at the blanks of the cracks as a function of applied loads could be monitored to determine the crack opening displacements near the crack tip, which were used to obtain the crack opening load.
  通过测量裂尖后两岸显微硬度压痕随裂纹张开闭合的距离变化，建立了缺口根部角裂纹裂尖附近的裂纹张开位移和载荷的关系，以此确定裂纹的张开应力。
• Using a knife, make slight indentations around the edges of the pastry.
  用刀子绕馅饼边沿刻小锯齿。
• Xtrace: iprint= awt traces all of the JVM internal AWT trace points to stderr, with indentations on entry and exit.
  iprint=awt将所有JVM内部AWT跟踪点记录到stderr，在进入和退出时进行缩进。
• Using a nano-sized needle, they poked the cement samples, and measured the indentations using an atomic force microscope.
  他们利用纳米级的针头刺进水泥样品中，借助原子力显微镜测得内部空隙的形状。
• Make four indentations into the condenser near the standard cone joint.
  在冷凝器接近标准圆锥接头处打四个穴孔。
• On Rock Fracture under static and Dynamic Indentations
  关于岩石的动静态侵入断裂
• Make sure the rectangular indentations on the synchroniser ring are positioned correctly with respect to the guide sleeve.
  务必确保同步器环上的矩形缺口相对于导套的位置正确。