pinions

英 [ˈpɪnjənz]

美 [ˈpɪnjənz]

v.  捆住，缚住(双臂); 固定住
pinion的第三人称单数

柯林斯词典

• VERB （尤指通过抓住或绑住双臂）使动弹不得
  If youare pinioned, someone prevents you from moving or escaping, especially by holding or tying your arms.
  1. At nine the next morning Bentley was pinioned, hooded and hanged.
     次日上午9点，本特里被捆住双臂、戴上头罩，然后绞死了。

双语例句

• Through a comparison of natural frequencies experimentally collected and numerically computed, the modified torsional model is proved to be more accurate than the purely torsional model and may be applied to dynamic design of epicyclic gearing with equally-spaced pinions.
  固有频率敲击试验表明，与纯扭转模型相比，修正扭转模型更具工程应用价值，可用以指导2K-H均布行星传动的动态设计。
• A Study of Tooth Longitudinal Modifications on Locomotive Tractive Pinions
  机车牵引齿轮齿向修形研究
• The hawk is aerial brother of the wave which he sails over and surveys, those his perfect air-inflated wings answering to the elemental unfledged pinions of the sea.
  鹰是波浪的空中兄弟，它在波浪之上飞行视察，在空中扑击的完美的鹰翅，如在酬答海洋那元素的没有羽毛的翅膀。
• Though the sword hidden among his pinions may wound you.
  虽然隐藏在它双翼下的利剑也许会刺伤你。
• The falling snow-flakes, sprinkling the pinions, gave it a special kind of solemnity.
  纷纷扬扬的雪花洒落在矮松上，更给它添了一种特殊的庄严肃穆的气氛。
• In this paper, multi-member planetary gearsets consisting of double pinions or duplex or triplex pinion are discussed, the kinematical equations and planar velocity diagrams and composite mechanism are analysed, and the theoretical method and procedure to design the layout of multi-member planetary gearboxes are established.
  本文讨论由双星或双联行星或三联行星构成的多元件行星齿轮传动，分析其运动学方程组和速度平面图及共复合机构，建立设计多元件行星齿轮变速箱的理论方法和步骤。
• The surface reaction films formed on pinions by sulfur-phosphorus containing hypoid gear oils after low speed-high load axle bench test were analyzed.
  用多种表面分析手段对硫-磷型双曲线齿轮油在低速高扭矩双曲线齿轮后桥台架试验后小齿轮的啮合表面进行分析研究。
• With it pinions can be machined with hob or single-tooth indexing, also can with shaft cut-in and radial cut-in method.
  可采用逆铣和顺铣方法加工齿轮，可以轴向或径向进行加工。
• These four pinions act as bridges between the side gears.
  这四组小齿轮起到连接侧方齿轮组的桥梁作用。
• Overcutting Test of the Rough-machining of Hypoid Pinions
  准双曲面齿轮的小轮粗切过切检验