scuffing

英 [ˈskʌfɪŋ]

美 [ˈskʌfɪŋ]

v.  磨损; 磨坏; 拖着脚走
scuff的现在分词

现在分词：scuffing　

柯林斯词典

• V-ERG (使)磨损;(使)磨坏
  If youscuffsomething or if itscuffs, you mark the surface by scraping it against other things or by scraping other things against it.
  1. Constant wheelchair use will scuff almost any floor surface...
     任何地板上经常有轮椅走动几乎都会有所磨损。
  2. Molded plastic is almost indestructible, but scuffs easily.
     注塑几乎弄不坏，但是容易磨损。
• VERB 拖着脚走
  If youscuffyour feet, you pull them along the ground as you walk.
  1. Polly, bewildered and embarrassed, dropped her head and scuffed her feet.
     波莉既困惑又尴尬，低下头拖着脚走开了。

双语例句

• Hot load and mechanical load coupling make piston to produce crackle, piston-ring glued and scuffing of cylinder bore and so on.
  热负荷和机械负荷耦合将导致活塞产生裂纹、活塞环胶结以及拉缸等。
• Study on calculating and test method for gear scuffing
  齿轮胶合的计算和试验研究
• The anti scuffing, friction reducing and wear resistant properties were investigated systematically on a pin on disc tester under engine oil lubrication condition.
  用销盘试验机在机械油润滑条件下对渗硫表面的抗擦伤性能，减摩及耐磨性能进行了系统研究。
• Research of Test on Gear Scuffing and Monitoring Technique
  齿轮胶合的试验研究及其监测技术
• The scuffing resistances of three phosphate coatings of manganese are evaluated in a MQ-800 four ball tester equipped with a new wear sample holder.
  在MQ&800四球试验机上装配了一种新的磨损试验夹具，评价了三种磷酸锰盐涂层的抗擦伤性能；
• Study of monitoring on line about the gear scuffing test
  齿轮胶合试验在线监测方法研究
• At the same time, for the power splitting differential gearbox the characteristics of compact structure, according to balanced specific sliding and flash temperature for the planet gear, the parameters of planetary gear can be optimized, gears can improved wear resistance and scuffing resistance.
  同时针对功率分流差动齿轮箱结构紧凑的特点，根据均衡齿轮的滑动率曲线和闪温曲线的研究，优化了行星轮系的齿轮参数，提高了齿轮的抗磨损、抗胶合能力。
• Analysis and Calculation of Fuzzy Reliability on Scuffing Resistance of Gear Drive
  齿轮传动抗胶合模糊可靠性分析与计算
• Standard test method for scuffing load capacity of gears
  GB/T13672-1992齿轮胶合承载能力试验方法
• The temperature effect of scuffing in sliding contact of steel is explored from the point of view of frictional temperature.
  作者从摩擦温度的观点考察了钢在滑动接触中擦伤的温度效应。擦伤试验是在环-块试验机上进行的。